Waterproofing for ceramic tiles
to bathrooms, kitchens
flexible, with high adhesion
one -component
Atlas Woder W is intended for waterproofing insulation of wet rooms (bathrooms, shower cabins, etc.). It enables flexible protection of the corners and expansion joints - along with the Atlas sealing tape and corners embedded in it, protects the edges of walls and floor sleepers and expansion joints. Seals the surfaces of walls and floors, around the passes of water and sewage installation pipes - along with the embedded wall or floor rings.
Main properties
ATLAS WODER in produced in a form ready to use mass based on polymer dispersion, fillers and modifying agents
is highly elastic - it can be used on substrates made in underfloor and wall heating systems and on other surfaces subject to deformations
It has high adhesion to typical building substrates - e.g. for concrete 2.2 MPa
is a coating seal - it creates a coating with a few mm thick (it must be protected against mechanical damage, e.g. as a result of pedestrian movement - it is necessary to make a protective layer, e.g. platelet cladding)
It is resistant to the formation of scratches in the ground - the maximum width of the scratch, at which the coating does not occur, is 2.2 mm
Before use, it only requires mixing the content of the packaging - it is a single component foil
It enables gradual consumption in 12 months - despite the opening of the bucket and partial use, it gives the possibility of applying the remaining part throughout the entire shelf life, i.e. 12 months from the date of production
It is convenient to apply regardless of the nature of the substrate-it is easily applied to both G-K, OSB plates, as well as on cement or gypsum plasters, metal and PVC elements
It allows you to easily control the thickness of the applied layer - both when applying with a brush, roller and steel trowel
provides excellent coverage after applying the first layer
It allows easily - visually - assess the thickness and uniformity of the applied layer - thanks to the intensity of the color and the structure after drying.
Main parameters
min. / max. Sealing coating thickness: 2 - 3 mm
Making a second layer: after 3 hours
Playing tiles: after 24 hours
WEAR
Average consumption for two layers depends on the absorbency and equality of the ground: